面向噪声丢包感知的无线网络拥塞算法

针对无线网络链路干扰大、误码率高等特点，以及TCP Westwood算法（TCPW）存在估算带宽时过度依赖包的反馈，缺乏区分传输过程中丢包类型的缺点等问题，提出一种TCPW拥塞控制优化算法--TCPW-F。该算法利用发送速率等构建拥塞因子[F]作为判断丢包类型的依据，同时对判定发生噪声丢包时的拥塞窗口进一步调整，避免噪声丢包引起的窗口下降，提高该情况下窗口的发送效率。仿真结果表明，TCPW-F算法在时延性能方面表现更优，单位时间抖动趋于稳定的速度更快。在同一信道带宽下增大包生成速率，改进算法的实时吞吐量明显高于原算法，具备一定的噪声丢包感知能力，无线网络的TCP传输质量获得较大改善。     

山东栖霞—大柳行地区金矿找矿靶区地质评价及优选

栖霞—大柳行地区位于胶东中部栖霞—蓬莱金矿成矿带内，是胶东重要的金成矿区，成矿条件优越。为了对圈定靶区进行优选分类，通过对该区地质背景、找矿靶区评价、找矿靶区优选方面展开综合研究，并结合勘查工作程度和矿业权设置情况，划分出3类预测区，选定了5个靶区为今后优先部署勘查工作的方向。     

安徽省铜陵市铁山头铜矿床地质特征及找矿潜力

铁山头铜矿床处于铜陵矿集区的中东部，属于扬子陆块下扬子凹陷中的铜陵隆起。矿床位于凤凰山矿田北侧，成矿潜力较大。综合研究分析认为：①接触交代作用使得岩体接触带及附近变质形成矽卡岩矿化带；②区内凤凰山岩体（花岗闪长岩）系成矿母岩；③矿体主要赋存于花岗闪长岩与三叠系下统南陵湖组石灰岩接触带上；④矿床成因类型为高—中温热液交代矽卡岩型矿床。     

广西箭猪坡矿床首次发现的石英脉型锡矿体特征及 锡石微量元素地球化学意义

箭猪坡矿床是丹池成矿带南端的一个以铅锌锑为主的矿床，随着2012-2014年在箭猪坡矿床钻孔中石英脉型锡矿体的首次发现，打开了箭猪坡矿床新的找矿空间。新发现的锡矿体矿石矿物组合类型主要为锡石+闪锌矿+脆硫锑铅矿+黄铁矿+石英及锡石+脆硫锑铅矿+石英+方解石。箭猪坡矿床锡石呈自形-半自形粒状，锡石粒径多在0.1～0.2mm，少数0.02～0.05mm，分布在含硫化物的石英脉裂隙中。物相分析显示箭猪坡矿床锡主要赋存在锡石中，锡石物相占83.33%～100%。阴极发光（CL）图像显示箭猪坡矿床中的锡石经历了两期结晶作用：早期锡石（Ⅰ）和晚期锡石(Ⅱ），早期锡石CL荧光亮度较小，呈暗灰色至黑色；晚期CL荧光亮度较大，呈白色至浅灰色。锡石单矿物SnO2含量91.623%～96.288%，平均94.03%，杂质主要有Fe、W、In等，其中FeO含量0.02%～0.52%，WO3含量多在0.02～1.34%，In2O3含量在0.476%～0.954%，Sn与FeO、In2O3呈负相关，锡石中FeO、WO3、Ta2O5、Nb2O5、MnO含量指示箭猪坡锡形成于中低-中温热液环境，成矿热液来源于高度分异演化的花岗质岩浆。通过与大厂矿田西矿带上部脉状锡矿体的类比分析，具有相似的成矿条件及矿物组合，推测所揭露到的脉状锡矿（化）体相当于西矿带上部脉状锡矿（化）体，而下部的网脉状、似层状锡矿体尚未揭露到，由此预测箭猪坡矿床深部找矿空间及找矿潜力大。     

高强不锈钢绞线网与ECC黏结-滑移关系模型

高强不锈钢绞线网与ECC的黏结是二者协同工作的基础，且黏结 滑移关系模型是其黏结性能的综合反映，故通过对17组51个高强不锈钢绞网增强ECC薄板试件进行单边拉拔试验，研究横向钢绞线间距、纵向钢绞线直径和相对锚固长度等因素对钢绞线网在ECC中黏结性能的影响规律。试验结果表明，横向钢绞线的设置可使黏结破坏由脆性破坏转变为延性破坏；高强不锈钢绞线网与ECC的黏结滑移曲线可分为5个阶段，分别为上升段、微降段、延性强化段、下降段和残余段。基于试验结果，对钢绞线网在ECC中的黏结破坏特征和黏结 滑移机理进行分析，在相关黏结-滑移关系模型的基础上，提出钢绞线网与ECC的黏结 滑移关系模型，并进行模型参数分析。所提模型及模型参数计算公式与试验结果吻合良好，能较好地反映钢绞线网与ECC的界面黏结滑移特征。     

Influence of cerium oxide additive and aloe vera biodiesel on a CI engine

Diesel is the main source of world transportation due to higher combustion efficiency, compliance, consistency and cost-economy. It is also a major contributor to the world prosperity since it is used extensively. Diesel engine’s emissions are the serious hazard to the world environment and it is measured to be the major causes of air pollution. The demand in biofuels for years created a scope for aloe vera into biodiesels. Aloe vera, having higher calorific value vnthan other plant sources used as biodiesels, enhanced us in making another alternative biodiesel, which has lesser emissions and better performance. In this research work, four biodiesel blends from aloe vera oil with cerium oxide additive are explored for their performance and emission characteristics. The results proved B30 (30% biodiesel, 68% diesel and 1% cerium oxide) gives good performance when compared to other blends.     

Inhibition of stress corrosion cracking in 304 stainless steel through titanium ion implantation

The effects of titanium ion implantation on the stress corrosion cracking (SCC) behaviour of 304 austenitic stainless steel were studied. Slow strain rate tests (SSRTs) were conducted on 304 steel in air and in 5?wt-% NaCl solution. The microscopic effects of ion implantation were evaluated by Stopping and Range of Ions in Matter Procedures (SRIM). Fracture morphologies and microstructures were investigated by scanning electron microscopy (SEM) and transmission electron microscopy (TEM). The fracture surfaces illustrate that ion implantation significantly inhibits the corrosion pits that initiate SCC. A dense passive film, which inhibits SCC, was formed during the ion implantation process. SCC initiation was restrained due to the dense dislocation nets that were generated by titanium ion implantation.

Highlights

• Ion implantation inhibits SCC susceptibility.

• The lack of Cr at the grain boundary leads to the expansion of SCC along the grain boundary.

• Implantation-induced damage leads to high-density dislocations.

• The surface was amorphised due to high-density dislocations.

     

臭氧氧化-循环喷淋法处理钨钼选矿废水

采用臭氧氧化-循环喷淋法去除钨钼选矿废水中COD,研究了pH值、臭氧流量、循环频率对COD去除效果的影响。结果表明: 废水COD去除率随pH值、臭氧流量、循环频率增大而增加,在pH值为10、臭氧流量3.0 L/min、循环频率4.0次/min条件下,氧化120 min后废水COD含量由131 mg/L降至11.5 mg/L,COD去除率达91.2%,满足《污水综合排放标准》(GB 8978-1996)一级标准。与O₂、NaClO处理废水COD的对比试验结果表明,循环喷淋法结合O₃表现出较好的COD去除效果。     

Solution combustion synthesis of cerium oxide nanoparticles as corrosion inhibitor

In this study, combustion synthesis of cerium oxide nanoparticles was reported using cerium nitrate hexahydrate as starting material as well as urea, glycine, glucose, and citric acid as fuels. The influence of fuel type on structure, microstructure, band gap, and corrosion inhibition was investigated. X-ray diffraction (XRD) patterns and scanning electron microscopy micrographs showed that CeO₂ nanoparticles with different morphologies were obtained depending on the fuel type. Microstructural changes from unreacted gel to sponge-like morphologies were resulted by varying the fuel type from urea, glycine, and glucose to citric acid. In addition to Ce–O bonds, Fourier transform infrared analysis showed carbon bonds of carbonaceous compositions from incomplete combustion which were declined during combustion reaction. Furthermore, corrosion analyses showed that samples synthesized using urea fuel released the most Ce⁺⁴ ions and could have better protection than other samples.